COURSE OVERVIEW

1) Introduction

2) Introduction to GUI

  • Design Modeler
  • Draw, Modify, Dimentions etc

3) Extrude Revolve, Sweep, Skin / Loft

4) Thin / Surface, Blend , Chamfer

5) Patterns, Body Operations, Face delete, Primitives

6) Creating cross sections

7) Static Structural Analysis

  • UDL on Cantilever beam
  • Point load, Simply supported, Roller supports etc..
  • Oil Bottle Analysis
  • Swing Analysis

8) Different type of loads on Bar

9) Modal Analysis

  • Bridge Analysis
  • Turbine Analysis

10) Rigid Dynamics

  • 4 – Stroke Engine

11) Steady State Thermal Analysis

12) Transient

  • Piston, Electric, Circuit Board Analysis

13) Linear Buckling Analysis

  • Slender Structures ( Bars & Beams )

14) Explicit Dynmic Analysis

  • Bullet passing through wall
  • Car body hitting a frame

15) Transient Structural Analysis

  • Gangway Bridge

16) Pre – Stress Modal Analysis

  • Slender Structures ( Bars & Beams )

17) Thermal Stress Analysis

  • EX: On Pipes

18) Fatique Analysis

  • About fatique tool theory

19) Engineering Data

  • Adding materials to the component

20) Meshing of the component

COURSE FEES & TRAINING METHODOLOGY

Training Methodology-1: (At ECC Premises)

Note: ECC is closed because of the Pandemic in March 2020 and will remain closed till the Pandemic completely ends. So, the students are advised to prefer online training only.

a) The student is supposed to listen the day’s prescribed syllabus through our e-learning video lectures.
b) Then he is supposed to practice the same in the computer lab, with the help of e-tutors.
c) The lectures are made in such a way that the student will be able to do without any staff help.
d) Still, if the students gets any doubt, then the staff will assist him.

Course Fees: Rs.6000/-

Training Methodology-2: (Completely online)

a) The student is supposed to listen the day’s prescribed syllabus through our e-learning video lectures.
b) Then he is supposed to practice the same in the computer lab, with the help of e-tutors.
c) Software installation help will be given by our Systems support Engineer.
d) The lectures are made in such a way that the student will be able to do without any staff help.
e) Still, if the students gets any doubt, they are required to make a note of the same and email us in the doubts section in our online portal www.eccindia.org
f) Our instructors will answer your queries within 24 hours (or) will come online through skype and shall answer all the queries from all the students.

Course Fees: Rs.3000/-

CONTACT INFORMATION

Contact Ms. Faheem on 98661-31068 between 11am-6pm for any queries (or) Email us at services@eccindia.org and mark a copy to training@eccindia.org

For any Queries on online training, please contact Ms. Naima between 9am-6pm on 97033-31068.